Construction & Engineering · Delaware County, Pennsylvania

PennDOT sets November 23 start for $18.5 million Darby Creek bridge replacement

The U.S. 1 crossing carries about 29,250 vehicles a day. PennDOT expects the first work to leave travel lanes open.

Infraday News Desk · Based on official sourcesPublished
Baltimore Pike in Upper Darby Township, Pennsylvania
Eastbound Baltimore Pike at Delmar Road in Upper Darby Township. PennDOT’s bridge replacement is at the separate U.S. 1 crossing of Darby Creek. Mr. Matté / CC BY-SA 4.0 (responsive crop) · Photo source

PennDOT plans to start work November 23 on the U.S. 1 bridge over Darby Creek between Springfield and Upper Darby townships. The department announced November 18 that J.D. Eckman will replace the deteriorated two-span structure with a single span under an $18.5 million state-funded project.

The contractor will remove the creek pier, widen the northbound approach for a shoulder and right-turn lane, relocate utilities and replace the signal at Rolling Road. Drivers can expect off-peak closures as work advances. PennDOT anticipates physical construction will finish in 2030.

Related coverage · New York completes $19.9 million Raquette Lake bridge replacement on State Route 28

PennDOT expects work to begin November 23, 2026, with physical completion in 2030.

Review the official next step →

Infraday+ research

Pennsylvania Department of Transportation

PennDOT is using state funds to replace the U.S. 1 crossing over Darby Creek.

Primary sources

You’re offline. Reconnect to load the latest Infraday updates.